Measuring Water-holding Capacity

I've begun taking water-holding capacity tests for all of our experimental trays! The process took some thinking to develop, but once we nailed it down, it was pretty easy going.

Measuring water-holding capacity

The procedure is: 
 

I. Drying Soil

1.     Heat up soil drying oven to 105ºC for an hour

2.     Take bag of soil out of freezer and let thaw

3.     Sample 45 ml of soil and place in aluminum weight boat

4.     Place remaining soil in bag back in freezer

5.     Place the aluminum weigh boat with soil in drying oven

6.     Dry for at least 48 hours

7.     Remove weigh boat and place in desiccator if not used immediately

II. Measuring Water-holding Capacity

1.     Measure and record 40 ml of dried soil alone in a tared weigh boat

2.     Wet a folded filter paper by submerging entirely in a water bath

3.     Let the wet filter paper drain for one minute until it is no longer dripping

4.     Weigh and record the wet filter paper alone in a tared weigh boat

5.     Add the soil to the wet filter paper

6.     Add 50 ml of water slowly and all over to the soil

7.     Repeat step 6 two times

8.     Wait three minutes for the water to drain until it is no longer dripping

9.     Weigh and record wet soil in the wet filter paper in a tared weigh boat

10.  Measure and record volume of water that filtered through

I've already gotten through the first 10 trays which are all Prairie A native plants. The first five are with added native inoculum, the next five are added with sterilized inoculum. The average water holding capacity of the added native inoculated soils was higher than the average of the sterilized inoculated soils for Prairie A! This is great news because for the Prairie A, the addition of native inoculum improved storm water retention!

More results to come later!

I-button data collection and soil sampling

Green roof in September

Putting the ibuttons back and collecting soil

The last week of September was big week for us! Dr. Chaudhary and I collected all of the ibuttons from their experimental trays and downloaded the data off of them. Then, Kelly and I restarted their missions and placed them back in their locations. Sarah and I also took soil samples from each tray to begin doing tests on the soil. I will do water-holding capacity tests and Sarah will analyze for carbon! I am currently researching water-holding capacity methods and will hopefully have news on that in the next two weeks. Until then, I am going to start compiling the temperature data from the ibuttons! 

 



Here are some pictures from the big day! Yay data!